Microscale Model Finishing

Micro Sol setting solution is for the most difficult irregular surfaces to be found on models. It
completely softens the Microscale Decal, allowing it to drape down onto the surface of the
model, conforming perfectly to surface irregularities without distortion. The most amazing
results in seemingly impossible places are possible because Micro Sol actually makes the decal
part of the painted surface. For that reason you should coat Micro Sol on for only a few
seconds and then leave it alone. It does the work. Do not touch until the decal has dried, as the
decal is very soft at this stage and could be easily damaged.

For the best results, first apply Micro Set to prepare the surface and enhance the adhesive.

To apply Micro Set: Use a soft flat artist’s brush and apply Micro Set where you are going to
apply the decal. Then slide the decal off the backing paper using a small pointed tip synthetic
bristle brush to carefully position the decal in its proper position. Blot the decal carefully with a
tissue or paper toweling, being careful not to disturb its position. Allow the decal to dry
overnight. It will then be ready for a protective coat of Micro Coat Flat, Satin or Gloss.